Polymaker Fiberon™ PET-CF17 1.75mm | 500g

Printing Temp:- 270 - 300˚C

Bed Temp:- 70 - 80°C

300mm/s

0%

Not required

Adhesive

100˚C / 10h (Only if the material has absorbed moisture)

All-metal hotend above 270˚C and Hardened nozzle

We strongly recommend 120°C, 10h annealing to achieve the best performance of the material. To avoid deformation of the prints during annealing, please
pay attention to the following:
1. Before returning the prints, please confirm that the prints have been printed for more than 24h, or placed in an 80-degree oven for 2h to eliminate the
internal stress after printing.
2. During annealing, do not touch the sample with your hands or apply any additional load to the sample.
3. During annealing, ensure that the temperature in the oven is uniform and there are no obvious obstructions that cause uneven temperature of the sample.
4. For prints with a bridge length of more than 3cm, or a thick layer on the upper part of the bridge; prints with large overhangs or small overhangs; all need to
add supports and anneal in the oven together with the supports.
5. For thin-walled areas with a wall thickness of less than 4mm, you can try to add reinforcing ribs or increase the wall thickness to avoid possible annealing
deformation.
6. In principle, the sample placement method needs to be consistent with that during printing, and it is best to enter the oven directly together with the base
plate.