3DLac Plus Adhesive Spray - 100ml

• Shake the vaporizer before use
• Apply on clean and dry surfaces for glass, mirrors, aluminum and any smooth surface
• On plastic surfaces, we recommend test first, the behavior of the product
• Apply a thin layer for best results
• Invert the vaporizer to purge the valve after use; If the diffuser is clogged apply a little alcohol to its mouthpiece with a cotton swab
• Try to always use in ventilated areas Avoid applying to electronic devices
• Once used, clean the diffuser to keep it in good condition and thus avoid obstructions
• Avoid use by minors

• 3DLAC can be applied on a multitude of materials, on which you want print with 3D printers. Depending on the materials will be obtained different adhesions, so we advise before printing large parts with certain technical materials are pre-tested.
• A greater quantity of Spray does help to make the fastenings stronger.
• When removing the parts, be especially careful as you do it, we recommend let the surface cool and if necessary give the piece a light touch so that it release easily

Please always Read MSDS and the label on the product that you have received.We cannot accept responsibility for any safety related.

Hazard statements

• • H225 - Highly flammable liquid and vapour.
  • H319 - Causes serious eye irritation.
  • H336 - May cause drowsiness or dizziness.

Safety Recommendations

• P101 - If medical advice is needed, have product container or label at hand.
• P210 - Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
• P280 - Wear protective gloves/protective clothing/eye protection/face protection.
• P304 + P340 - IF INHALED: Remove person to fresh air and keep comfortable for breathing.
• P305 + P351 + P338 - IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
• P501 - Dispose of contents/container in accordance with local/regional/national/international regulations.